Warranty, Use, & Basic Care information

5 YEAR LIMITED WARRANTY

Each CASSOTTO Lever comes with a 5 year limited warranty, under normal use, for the wooden body and carbon fiber core.  The Taffijn tips, aluminum heads, aluminum inserts, and exterior finish are excluded from the warranty.

In the event of a lever failure, email Randy (88onpitch@gmail.com).  Your equipment can be shipped to:  88 On Pitch   149 High Valley Dr   Canton, CT 06019  (shipping charges apply).  If the lever cannot be repaired, a new lever will be provided to you.

 

WHAT TO KNOW ABOUT AIRCRAFT GRADE ALUMINUM 

Black anodization has been added to the head/tip inserts for aesthetics.  During regular use, markings may appear and/or the black anodization may come off.  If this happens, your lever should continue to work as intended as confirmed by metals engineers.  Use a tissue or soft cloth, wipe away any residue, discard the cloth, and wash/clean hands as necessary.

THE TIP INSERT / HEAD FOR MAGNETIC RELEASE HEAD

A tiny gap of approximately .001” (0.00254 centimeters) is standard between the tip insert & head to allow the tip insert to be removed from the head without the use of tools.  You can add 1 (or 2 if needed) small, square pieces of traveling tape to an inside wall(s) of the head (Schaff product #6025) to reduce or remove the gap.

CAN I REMOVE THE TIP FROM THE TIP INSERT?

For magnetic tip release owners, it is strongly recommended to leave one designated tip on with a single designated insert.  Removing steel tips from aluminum tip inserts can increase your chance of damaging the aluminum threading.  If you must remove the tip, do not place your lever on the ground and stomp on it.  Use the #11 tip wrench from Schaff and you should be able to remove the tip from the insert, without placing it on the ground, using force by rotating the tip counter-clock-wise until it comes loose from the insert.  You can also use this method for the threaded tip release.


CLEANING

These levers are finished with blend of a 2 part epoxy & special ca.  Staying away from the metals, use soft, dampened cloth with soap & water over the finished wood & carbon fiber core.  You can also use Meguiars #17 & #10 for light surface scratches & follow the manufacturer's instructions.  Cleaners with silicones will void the warranty.   KEEP LEVER AWAY FROM HIGH HEAT.  Temperatures above 110˚ may cause the 2-part epoxy finish to soften.

*88 On Pitch takes no responsibility for bodily injury or damage caused by any use of the CASSOTTO Levers, metals, or equipment supplied. nor does 88 ON PITCH claim to provide any cure or relief for any ailment or disease. ©2022